Elevator Forum

With no load u want it to stop slightly above every stop. In both directions.

If it's a single speed machine u will b relying on the break and your selector to stop the car. It's definitely not easy

I hooked up to another controller and had the same issues .. I'm getting my ims fixed soon.

Yes service tool is not working properly. My monitor screen works but I can't transfer job files from CPU to lap top and smart fast is not responding ...

Thanks dirt. So you are saying I should have 24v to con 6-3 olts and I should not have 24v on con6-4 olto ... How do I change that input ? Remote fast...

Another issue with this is remote fast commands are not responding properly When I type flt it says FLT 0 thru 9 =0When I type rfl it responds with #

Ok new I motion board worked great. But there is no led screen on the board. All programming must be done with service tool.. so any one who has to ch...

JABOut of service -car to lobby

I just got a new board from Unitec. They actually sent it in the blue box .. but I just wanna swap boards which should be easier .. there's no instruc...

The problem is We had hoist motor rewound and it doesn't have enough power to take off in down direction. Up works fine.

Even when it stays on the set up mode parameters list after I change to left hand and allows me to continue to the rest of parameters as soon as I cha...

ok. Still having trouble here. I get it to save single slide left sometimes. Doin a reset doesn't work ... I just have to keep hitting enter after I c...