Elevator Forum

F10 fuse goes to area 17. ( car serial link ). I have a small board in COP. Is that my serial link ? Does anyone have a picture or write up on this ? ...

I think it’s a 211. Not 411

This keeps happening intermittently... I can not find the DCL actuators Is there any way to disable door lock monitoring on the controller Interface ...

I had 48v to INB in cop. But not to INB on controller. Touched the wire and IN picked. So loose wire to INB was the problem. Has nothing to do with sh...

IN is not picked Fuses good Last edited by Jluff; 07/17/21 12:43 AM.

Are Those test points on the power supply in COP? That’s definitely my problem. Does vertical express sell the power supply ? i have never replaced on...

Thanks dirt. Is it possible the swing return power supply is only affecting my car top boards ? I originally ruled that out because I was able to comm...

Also is a py2 interchangeable with a py4 door board

On a py2 door operator is 675et2 software compatible with ET4 software ?

What’s your email

I have had to replace a few stop switches. Do You have all the testing procedures? Last edited by Jluff; 07/01/21 08:10 PM.

Does anyone sell dmc software anymore ??