Elevator Forum

Ok. Thanks dirt. I wonder how this car ran for a year with no shutdowns

No. BLO not there under port 8

Did a FJR and got 1074 and 1110 .. also turned power off and manually lowered car into pit. Turned power on and got same results. 1074 and 1110 as car...

Update. Every time car gets sunk in pit i get 24v to prsw . Causing shutdown. Car still levels fine after sync and shuts down level at bottom terminal...

It seems the problem is my jack low pressure switch .. I wonder if my up leveling strainer is causing this. Last edited by Jluff; 07/30/21 11:44 A...

What can cause that? The car binding during sync ? Bad synchronizing valves?

Fault code is 1074. In manual it says pressure switch active . On the UIT is says 1074 jack resync low pressure shut down .I manually re sync it and i...

So Maintentaice in the building had been recycling power every time b4 I got there until today. Now I have a 2nd code. 1074 jack resync low pressure. ...

It’s probably under job requirements sub menu off block select adjustments.

Thanks dirt. Can Adjustment 025 be changed with UIT on controller ? Last edited by Jluff; 07/29/21 01:18 AM.

Yes that is only fault I’m finding. But it’s always in the basement when I find it. So maybe you are right. I will check My back side magnets. If I re...

No dcl n dol cigars on car door hangers. This is a LD-03 door operator with a 6300pa6 door board. It talks about dcl actuators on door operator cover ...

Thanks. I will check for that. I can’t find these things yet. But I didn’t look on the gate hanger rollers

There is no magnets for DCL and DOL. it’s an encoder. Cam looks ok. Keeps shutting down once a week on bottom terminal landing.

COP board is bad. Unitec has a 4 week lead time on this board. Does any one else sell these ? ABA26800TV1