Elevator Forum

The "ready contact from the drive" that you are referring to? Is it the contact wired from GV to LCS in the drive? If it is, this contact opens when t...

When there is no demand, it is correct that the car gate will not be fully closed. And when a call is made power is applied to the operator to hold th...

Monte,I have a limited amount of CEMCO info. I'm not seeing a 2I?

Is this the same job? Are they different units?Ok this is starting to make sense. 44 usually comes from a hatch door lock getting clipped. But, it can...

58 is an auto reset 3 or more in an hour94 is your EMSD24 is where is suspect is the root of your trouble. Your demand and reference velocity are to f...

Can you give us more details?Which controller is it? Example would be SMA-7P-RSBLWhat have you looked at so far? Is the selector stepping properly?Sor...

Is it that the car starts to move prior to the DCL openning? My book reads "DCL input is not active when the doors closed".

And good for you for having the courage to admit your not perfect. Do look now but your showing you have character.

I agree with solidstate, that's a small issue. You'll have plenty of chance to do it again...Trouble-shooting is an art form. Learn from your mistakes...

MCE "like all manufacturers" created several versions through out the years. In my experience the door open circuit all had a common series with the f...

Do you have prints for this unit? Is DZ on the selector board picking at each floor?Did you see if the car is level at each floor?

Monte,Just had a trouble with a 2BC 3 stop. What I found was the 39 relay gap was too small not allowing the relay contacts to make & brake proper...

You can try EMIporta. Maybe they can rebuild what you have...[email protected]

Coriice,You use the words suspicious and assumption to describe us. And yet no one has labeled you.You have been honest saying you are a building owne...

ABE,Some people collect coins or stamps. Jim is a collector of prints and Manuals. Jim has been a great resource for such materials. And over the year...