Elevator Forum

There are not removable EEPROMs on the newer 211. The Baseline software and parameters are stored on surface mount FLASH. I have a manual on the proce...

You could check the Permission Change Log after it stops running to see if there’s a corresponding change. PCL command in remote fast.

I think I found it. The multidrop board with load weighing is an ARE2 and requires another position sensor.

Do you have a part # for the one with a 485 plug and load weigher plug? I sure can’t find one. The old ABA26800AED is obsolete.

That is complete non-sense. If anything, you are just adding an extra run and door cycle.

Pretty sure that is a Miprom 21 CPU with the piggyback PROM board. I suggest you get a hold of a Tool but you might try turning one car off at a time ...

There should not be an external repeater on a TAC32T, the FWIA has a repeater in it, probably what you are seeing on the print. There’s no reason what...

IMS through the CWIL is terrible but I can’t imagine it causing individual IOs to drop.

What kind of controller is this drive on?

If it’s like the one TKE has, there is a unit specific module programmed to the GO # that goes in the controller, then you activate it with a tool. Po...

I know the equipment goes in the machine room, and the GEN2 is one of the better MRLs. My point is, if you have a conventional machine room, why use s...

In my opinion, if you are doing a full Mod and replacing the existing machine, I would go for the Gearless. One caveat though, some companies have gon...