Elevator Forum

I say 010 because that’s how it works when you turn off/on the doors and disable hall calls on 311/411. Again, I’ve never tried with independent. Best...

The input should be at address 391. Disable write protect, go to 1-3-2, hit 3-9-1 Enter. If it’s a 000, make it 010, if it’s 010, make 000, Enter. Som...

So you have: P150 from the controller and 12v (10.75) from the power supply to door board? Do you have a watchdog LED on the door board? To get the wa...

I think you have to hit Shift - 7 - Shift - Enter to get to those parameters Last edited by Indirtwetrust; 07/03/19 12:28 AM.

I have seen a Schindler document on this. But most communication wiring doesn’t like to be coiled up. SPI loops especially.

I doubt it’s door related but it doesn’t hurt to make sure DCL6 is set correctly. Some of these encoder faults can be hard to track down, especially o...

What kind of drive?

have you asked the Mall if they will help out with surveillance camera video?

Technically it’s a crossover cable but I’ve never had a laptop that wasn’t capable of using either. If however, you ever connect a CPUA directly to a ...

You have to do the TECF/TECR before the TECC. TECCR, TECF/R TECC

What all is in the loop? If it’s all S24-1 boards, get one and replace each, one at a time. Also, how did you verify the cables are good? Most plug in...

Ya, don’t bother with the TLS keypad. Just get new enough IMS to use the drive Smart Fast. And if you really want to get into it you need the Daq soft...

The blue relays are Finder, new brown ones are Schrader. I actually suggest that if you have the blue finder relay sockets that you keep the finder re...

Man, I saw this exact problem, same print number too. I want to say it was in the timing of the 2 contacts on STX. I ended up just adjusting a relay c...

The controller is going to do some goofy things when you pull relays out and try to run it. And ya, the up to speed contact on the starter is almost d...