Elevator Forum

It needs a software update

PM me the job number

P8 is the overall torque limit. I’ll send you something on that. There’s also a capacitor and a bridge rectifier under the door bard.

I think you need to reload. Port 9 should be your valve coils and from the what you’re describing, they are. 9-1 and 9-2 are VC1A and VC1B, down slow....

So are there sensors in the hoistway then? There must be. And something is wired to the inputs if they’re changing state. What port are the IOs in? Lo...

Couple things…Believe it or not, that heat “damage” up there is actually normal for those boards. Not saying something didn’t actually fail or short t...

I’m not sure what the voltage on the 485 comm should be but I would try swapping the shielded pair with the phone line

There are 2 channels, must count every time either channel passes a slot.

That’s what I would expect it to look like with no sensors. Can’t explain the 1068 faults. What generic software is in the controller and when you do ...

They did have a shaft setup but no LON download. FCBs were addressed with jumpers.

What doesn’t make sense though is how do you get a 1068 without any jack sensors to tell the controller it’s out of sync? Even if the jacks were so fa...

They’re good controllers, blue tool is correct although I’ve seen some newer black ones from Otis that work. My old black one does not.One concern is,...

Are you sure there aren’t even dynamic sensors that come 12” before the top floor slowdown? TPDL and TPDR. And a WJR command should tell you what has ...

The shifter board is the big one in the controller. FCBs are the floor control boards for the hall fixtures so should be in the gutter or a box in the...

Is Jcjmowrey out there? What was the resolution to these original problems?