Elevator Forum

Are you sure it's the belt and not a bearing on one of the sheaves?

Always good to see a success story!

After a full power down and reset of the MCSS, does the fault still exist?

Related with sim card? Can I change it with cadi? Last edited by heisenberg; 03/16/19 04:16 PM.

Maybe when not in use, the door fully closed or open switch or relay is gaining resistance? Did you check all limits?

3300 is far better for configuring than the 5500Pm me if you need further info on them

I would be monitoring incoming voltages from the grid. There could be spikes in voltage that are damaging.

Simplex. Yes i did, after pressing enter on le 00, I get CF _____Constantly scanning?

Many reasons, what codes are you getting? What model?

You're shorting those contacts and still getting pebobatlow error?I had this fault before, there was a fault on the GCIOCF board (the board with the r...

Might be a silly suggestion, but have you tried a complete power down and reset?

Ha! Exactly what I predicted...The media here in Australia is a joke, never a mention of elevator techs aiding in the help of rescuing passengers, alw...