Notifications
Clear all
Topic starter
09/01/2019 3:51 pm
Pretty confusing fault on this 3300, replaced a vandalised LOP with new, did a LOP teach in via the configuration and the new LOP successfully calls the lift to the floor.
However when placing a call the buttons do not stay lit up or 'latched' but the call has been registered.
I've had a scan through parameters and cannot find anything to adjust this.
Any help would be appreciated
10/01/2019 12:24 am
Is it duplex? did u try to cf 00 le 00
Topic starter
10/01/2019 12:27 pm
Simplex.
Yes i did, after pressing enter on le 00, I get CF _____
Constantly scanning?
10/01/2019 7:27 pm
Scanning finishes after 2-3 min. you can try to exchange the button with a working lop and try to reconfig by cf 00 and "--"