Elevator Forum

HelloI did not see reply LED on CPU board.Check 5 volt supply. Make sure no ac ripple.

believe it or not, we had a hydraulic with a lot of water and they installed an aerator witch I thought would never work, but it did

The last three WRC controls to fail this way was fixed with a new valve kit.

Is unintended motion fault the only fault when this happens, or do other faults happen with same time stamp.

I'm sorry, I'm not helping much, but sounds like a 2 person job as there seems to be nothing to I can think of at this moment.

I hate MRL's. Dose this system stop when it sees a door zone or are you on your own for that as well.On another note it won't matter much when your de...

Excuse this stupid question, but is there a screne showing encoder feedback

Hello may I ask, who is the manufacturer is

Hellowho's the manufacturer

if I am not mistaken, there should be a perameter in the drive switching direction

check the N O auxillary contacts on M contactor.as for your tac 50-04, use usb or ether net, and you need the black IMS icon on your lap top

hello.#1 gearless or traction#2 is there a speed command

Forgot to mention that if the brake gets hot, the holding voltage may be to low and the brakes may drag due to not enough lift.