Elevator Forum

E-man
@e-man
Honorable Member
Joined: Jan 1, 2010
Topics: 19 / Replies: 461
Reply

Have you done a brake job? When I've had 87s, it was either the BLS module, brake contact or the brake was sluggish and/or not adjusted correctly. I w...

14 years ago
Reply

I have some Haughton stuff on my route but I'm not all that familiar with it nor am I sure which controller you are working on. Have you looked at KLS...

14 years ago
Reply

We cover up the smokes plus all other equipment in the MR (if we can) and blow them out, the generator (or motor) is gonna come out either now or late...

14 years ago
Reply

I've only done it 2 or three times, I do remember the first couple had red paint indicating the master floor. Look for red paint somewhere in the midd...

14 years ago
Reply

Just recently went down that road again... hadn't done one in many years, not fun. Use a long run button and do like Len said and set it up on inspect...

14 years ago
Reply

If it has an MHC and RMH PCB it's a 2. Last edited by E-man; 08/09/12 11:41 PM.

14 years ago
Reply

I have an Otis car that does that if I force it to run from the controller. My selector is up on the secondary next to the machines and the car calls ...

14 years ago
Reply

If it has a drive, it could be as simple as a drive parameter being wrong. We had an MCE Engineer come to teach a class at our office and I suggested ...

14 years ago
Reply

Had a similar problem with a relay hydro blowing a fuse on someone else' route about once a day. My boss "go down there and fix the damn thing". I had...

14 years ago
Reply

New Construction (typically) will roll up the extra LON cable and shove it back in the push button box, duct and/or in the controller. I've heard it b...

14 years ago
Topic
14 years ago
Replies: 0
Views: 1533
Reply

I have a few cars (even an original 321A) with the TDC in the car station. I figured the OP was talking about an IDD, TDC's and/or QKS's don't have LE...

14 years ago
Reply

Dover changed out the old Otis operators years ago to GAL's. We were trying to push a mod and all the customer would spring for is operators, that's a...

14 years ago
Reply

Carbon everywhere, guess I'll meg it. I forgot to check the controller. The machine says 330DM on the side. Went through and ohmed lots of circuits, t...

14 years ago
Reply

Never seen a QKS16 or TDCB PCB. Sounds like (from the error) that the reversing edge is bad.

14 years ago
Page 26 / 32
Scroll to Top