Elevator Forum

look in car station board see if wires hooked to six pin plug top right thats your lockouts

So it doesn't use a retiring cam.I would look in hoistway devices for bad floor

Load Weight

Don't tell me new mechanic an old timer told them use 2 clamps an they new more.I just retrieved one same thing lol strong magnet but short piston

Had same issue just doing phase 1 recall you need to have blue tool an reset M-1-5-1/M1-5-2/M2-4then blue key/M2-2-3 blue key

change the 4 battery's in bottom of controller

re pipe unit from pump

isnt there a command that will let you run 1 time without encoder or tach then you have to recommision to run again

need to upgrade you software

Go onto HW web site they have documents for your job not that bad to do they don’t recommend Vaseline an graffit they want it dry I use a dry graffit ...

try cleaning belts an sheaves

try removing boards an push on chips to seat them

Thanks a lot .did int got car to move on inspection now copying number from other cars.You all have a Happy an Safe New Year see you in 2020 b