Elevator Forum

Check your switch tree mounted to the car. Those switches sometimes break the shunts or wires inside the switch.

Finally did it to me elevator would take off and run very slow in both up and down directions ended up being bad contacts on Moxx relay.

Might try access Elevator circuit boards.com

Looks like a fantastic candidate for modernization get some bids.

We have had good luck with smartrise. It’s the ec pixal we see a lot of problems with?

Honestly this elevator is 44 years and it is near the end of its life even if you get it fixed you should probably start budgeting for a modernization...

Did you replace the motor encoder or governor encoder? You might check your governor rope and sheaves. Sometimes rope grunge will build up and change ...

Ended up being the hall lanterns were never addressed in software. We addressed the boards according to the prints then turned on the bit in the cpu f...

I’m with dirt on this one never seen an upgraded operator for a dmc as the signals all go through dmc485 com channel? Got a picture of the upgrade I’m...

Check your selector adjustments and make sure you have counts for your floors. If it’s missing those you may have to do a hoistway scan before you can...

If you like peace and quite move to the country Building noises come with Highrise urban living. Just my 2 cents we get these kinds of complaints from...

TK had one in IMS for their equipment.

Anyone have LEV 2 info they can share?[email protected]