Elevator Forum

Thank you for the reply,I checked voltage on DZ1 (24.2) and DZ2, (23.8) I also replaced all the schrack relays with Finders, noticed immediately they ...

Yes correct, I am saving 1 parameter at a time as I go down the list, however something is off, this is a 4 stop, when I change the number of floors i...

Thank you for the response, very helpful. I started entering all the correct parameters under CLC adjustments, starting at 001. However when I get to ...

I don’t understand, please explain

This is an old 300a, no segment display of any kind.

Yes I did, a few times. Also the communication led dose not flash accordingly compared to the unit next to it. I took the board I replaced and sent it...

I found a spare CNA board in the machine room. Who know if it’s good or not. I swapped it out with the board on the controller and now I have restored...

Ok, I’ll try that first thing in the morning.