Elevator Forum

Ok, went back to the job. Just as suspected, the signal wires for the K55 input were taped up in the bottom of the controller under the solid-state st...

I think I have it figured out. I referred back to a post that Dan Zeitz wrote about an MPHI that had a similar issue. If the computer doesn't see the ...

What drive do you have, DSD 412?????

Are you referring to the Motion Smart-Traq controller for the 6970 Door Operator?If so, here you go: Last edited by Administrator; 04/28/12 12:18 A...

We have lost so many of these I was running out of room to store them. I finally had to dissect one to see what was causing the failure. Here's what h...

Have you installed any of these machines in the states? If so, which controller manufacture did you pair it with? What is your overall impression of t...

In the photo gallery click on the "New Image Tab" in the upper left hand corner. Then choose "Image Manager" below the description box. The "Image Man...

I've never installed one with 24 volt door locks. All of them have been 120 VAC. Were they using 24 volts in the early versions?

The pricing is competitive to the MCE M2000 controller. I think in some cases the Smart Rise is a little cheaper. I do like the customer service at Sm...

Hey Vic, I did think of throwing it off the roof a couple of times. This particular controller was the Bitch of the Bunch. It was really windy on Sund...

This is a building in Norwalk. Two passenger elevators and one service elevator.