Elevator Forum

Notifications
Clear all

TMS 50

11 Posts
4 Users
0 Reactions
8,986 Views
(@crustyone)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter   [#29852]
I keep getting two error codes 50 & 12. Mostly error 12 Anti Creep on a hydraulic lift three floors with a TMS50 controller.
Can some one help me solve this one.



   
Quote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@crustyone)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter  
Thanks Rolly. Do you have any idea what would cause this fault. Do I need to do a learn run? If so how is this carried out.



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
If you don't have a rope gripper could be a dip switch setting. Or Possibly a brake poblem.. micros etd..

Last edited by Rolly; 09/02/20 08:03 PM.


   
ReplyQuote
(@crustyone)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter  
Thanks Rolly. This unit is a hydraulic, so no brake. The Governor switch is all good. The dip switch is number 3, tried it in the other position but no change so returned it to its original position. I don't understand your reference to (micros etd)
Any other suggestions would be greatly appreciated.



   
ReplyQuote
(@heisenberg)
Reputable Member
Joined: 17 years ago
Posts: 280

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
Had a lot of bad boards.. Low end junk system. make sure you get the right board for your silk screen cover if you do get a new board,



   
ReplyQuote
(@jadam)
Estimable Member
Joined: 17 years ago
Posts: 110

   
ReplyQuote
(@crustyone)
Eminent Member
Joined: 17 years ago
Posts: 25
Topic starter  
Thanks Jadam.
What do you mean re the LOCKING MAGNET? can you expand your knowledge on this device.
Thanks



   
ReplyQuote
(@jadam)
Estimable Member
Joined: 17 years ago
Posts: 110

   
ReplyQuote
Share:
Scroll to Top