Elevator Forum

TKE Smarttech II do...
 
Notifications
Clear all

TKE Smarttech II door operator

6 Posts
4 Users
0 Reactions
3,906 Views
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359
Topic starter   [#34002]
Got a Smartrise controller with this door operator and getting a serial comm loss fault and occasional encoder fault. If I put controller on door disconnect it’ll run all day. On normal, when door opens, it hits DOL but door motor keeps running. Already swapped motor/encoder with other car, no change. Looking for suggestions. Thanks



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359

   
ReplyQuote
 ABE
(@abe)
Reputable Member
Joined: 17 years ago
Posts: 338

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
They may always have a 2064 when wired discretely. Sounds like it isn’t seeing the open limit, does it ring out? And do you see the DOL LED on the UIT interface board? If so, do you see it in the actual door board underneath? They can be wired different ways but maybe the serial comm failure is between the 2 boards and the limit not getting from the top to the bottom. Not sure though, don’t really see those on anything but TK controllers.



   
ReplyQuote
(@alex-elman)
Trusted Member
Joined: 17 years ago
Posts: 54
 
Smartrise boards are too sensitive to noise,they are far from perfect! When the door hits DOL but the motor continues running it would draw more current and will generate more noise and that causes Smartrise boards to fail.



   
ReplyQuote
Share:
Scroll to Top