Elevator Forum

Tac50-04 synergy H ...
 
Notifications
Clear all

Tac50-04 synergy H fault 690

12 Posts
4 Users
0 Reactions
13.6 K Views
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24
Topic starter   [#9943]
Swapped all boards. Checked brakes. Changed encoder today and did alignment procedure. Still faulting 690. Frustrated.



   
Quote
(@traction)
Estimable Member
Joined: 17 years ago
Posts: 123

   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24

   
ReplyQuote
(@sbrmilitia)
Honorable Member
Joined: 17 years ago
Posts: 448

   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24
Topic starter  
V3F25 and yes 690 is first. Swapped inverter Interface, encoder interface, 2407MC, constant current regulator and ENENCT cards. New Encoder. Fault occurs right after brakes pick and voltage is sent to motor. 2407MC board fault on uit says No Encoder.



   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
It sounds like you looked at this already. But the way your last post sounds, you motor isn't turning soon enough.
Also does the brake pick too slowly? Is the motor trying to pull through the brake before it is completely lifted?



   
ReplyQuote
(@sbrmilitia)
Honorable Member
Joined: 17 years ago
Posts: 448

   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24
Topic starter  
Good question. But when I was done it said alignment complete. Does the sheave move during this process?



   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24

   
ReplyQuote
(@sbrmilitia)
Honorable Member
Joined: 17 years ago
Posts: 448
 
It will run on inspection for you to get it out of the overhead? When you run it on inspection are you getting any speed feedback?

It's a goofy way that encoder attaches to the shaft. There is a screw that jams into the side of it. That was on a torin machine but I think it's the same encoder set up.



   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24

   
ReplyQuote
(@dsmithelev)
Eminent Member
Joined: 17 years ago
Posts: 24

   
ReplyQuote
Share:
Scroll to Top