Elevator Forum

Notifications
Clear all

Tac 50 hall boards

7 Posts
4 Users
0 Reactions
8,230 Views
(@cucuvator)
Estimable Member
Joined: 17 years ago
Posts: 81
Topic starter   [#11916]
I need the hand tool to program hall boards? I replaced one hall board and no take hallcall on that floor .Any suggestions. Tac 50/04.

Last edited by cucuvator; 08/29/14 02:10 AM.


   
Quote
(@silly)
Estimable Member
Joined: 17 years ago
Posts: 215

   
ReplyQuote
(@cucuvator)
Estimable Member
Joined: 17 years ago
Posts: 81

   
ReplyQuote
(@silly)
Estimable Member
Joined: 17 years ago
Posts: 215

   
ReplyQuote
 Luis
(@luis)
Active Member
Joined: 17 years ago
Posts: 11
 
To program or learn the HN's board you should do it by using the IMS, on the Remote FAST window, hit the followig commands:
-TECCR to clrear the the existing progrannations.
-TECC to learn all the communications.

Than you can do a TECF/R for testing if there is any HN missing or a DHNF/R to see the states of all HN's.



   
ReplyQuote
(@silentkiller)
Active Member
Joined: 17 years ago
Posts: 7

   
ReplyQuote
 Luis
(@luis)
Active Member
Joined: 17 years ago
Posts: 11
 
If the issue is teach in the HN boards, i'm sure.

-TECCR-clear the existing programming
-TECC- to learn all the communications devices including HN's, of course.

VERIFICATIONS (CHECKS)
-TECF (if one access) TECR (for 2nd access)-check if there's any HN faulty.
-DHNF (if 1 access)- show the states of all HN's (version, communicating or not, etc)
-DHNR (for 2nd acccess).



   
ReplyQuote
Share:
Scroll to Top