Elevator Forum

Notifications
Clear all

OTIS LRV-3 MYSTERY

7 Posts
6 Users
0 Reactions
15.6 K Views
(@bk2fla)
Estimable Member
Joined: 17 years ago
Posts: 60
Topic starter   [#6469]
Have a 3 stop LRV3 at least once a month gets stuck with doors closed,exit elevator light on, if doors are forced open nudging buzzer goes off and door nudges close and thats it!!! have to reset controller in order to run. i know its not much info but thats all i have. any idea what may be the cause? maybe bad magnetic sensors on COP? any help or suggestions would be greatly appreciated.



   
Quote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132
 
You unlucky bastard.
Do you know if it was upgraded to the lrv 4?That would be the pc controller behind the cop.

Check your door locks,gate switch and cam switches in the door operator,assuming it's the otis version of gal,QL.

Reseat the plugs on the pc board behind the cop.



   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
just something I have found on LRV'S, 75% of the problems are caused by the door open, door close relays. these are the 2 black plastic modules that plug in to the relay board. I always replaced these before doing anything elese.



   
ReplyQuote
 tony
(@tony)
Eminent Member
Joined: 17 years ago
Posts: 36

   
ReplyQuote
(@bk2fla)
Estimable Member
Joined: 17 years ago
Posts: 60

   
ReplyQuote
(@sooner40fan)
Active Member
Joined: 17 years ago
Posts: 4
 
Had a similar problem. Check your voltages off the power supply above your processor board. If the voltages are fine, possibly the processor board.



   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194
 
..upgrade to an LRV4..processor..have had this problem before..this fixed a lot of issues..might be hard to find a replacement LRV3 processor board....



   
ReplyQuote
Share:
Scroll to Top