Elevator Forum

Otis Gen 2 Lost Pro...
 
Notifications
Clear all

Otis Gen 2 Lost Program?

3 Posts
3 Users
0 Reactions
735 Views
(@aryankee)
New Member
Joined: 17 years ago
Posts: 1
Topic starter   [#39844]
So I am new to this and I may be in over my head but I thought that I would give this a try. We have an Otis elevator and it was installed way back in 2014/2015 timeframe. The building has been dormant for about 10 years. When we started powering everything back up, the elevator actually showed what floor it was on and functioned. We ended up powering it all down and leaving it that way. Now I get the battery fault light which I know they are all bad and need to be replaced. I don't have much info on the elevator so I bought a blue tool in hopes that I could get some codes off of it to see why it won't work. I figure with the batteries dying that it lost all it's programming. There is a small memory card that looks like it plugs into the same port that the blue tool does. I figure that has all the original settings. I'm just not sure which direction to go. Thanks in advance for any help.



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Go directly to a licensed elevator mechanic. It’s not something to mess with and you could easily make it a lot worse with a blue tool if you don’t know what you’re doing.



   
ReplyQuote
(@bowtiedrooster16)
Reputable Member
Joined: 17 years ago
Posts: 279

   
ReplyQuote
Share:
Scroll to Top