Elevator Forum

otis 411 ucm fault ...
 
Notifications
Clear all

otis 411 ucm fault reset

9 Posts
8 Users
0 Reactions
29.6 K Views
 Jim
(@jim)
Estimable Member
Joined: 17 years ago
Posts: 87
Topic starter   [#7294]
i have a 2925 fault logged. pressing the ucm rst button wont reset it. do i have to reset a parameter back to 0 like the 355 controls befote it will run again?



   
Quote
(@greenpants)
Reputable Member
Joined: 17 years ago
Posts: 276
 
why did it go on UCM? any other faults?place car on MR insp, hold the ucm reset button(middle of board toward the bottom) an you should hear the ucm relay pull in and then push the mcss cpu reset button or por.



   
ReplyQuote
 Jim
(@jim)
Estimable Member
Joined: 17 years ago
Posts: 87
Topic starter  
no dice. 2908 error too. ucm and ucmx didnt pick when ucm rst pressed. no display on the drive either. this occurred after somebody manually tripped the gos with the car on inspection.



   
ReplyQuote
(@uppo72)
Honorable Member
Joined: 17 years ago
Posts: 562

   
ReplyQuote
(@billvator)
Estimable Member
Joined: 17 years ago
Posts: 93

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904

   
ReplyQuote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132

   
ReplyQuote
(@take-the-stairs)
Estimable Member
Joined: 17 years ago
Posts: 120
 
I agree, with Elevatedone. Also make sure your safety stuff is not jumped out. When the car is reset it does a self check, you will get this fault.



   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194
 
If It is 411/MMS or a Gen2...no display on the drive..is not a good thing..whatever the fault on the MCSS there should always be a display on the drive...



   
ReplyQuote
Share:
Scroll to Top