Elevator Forum

Notifications
Clear all

Otis 311

12 Posts
7 Users
0 Reactions
15.4 K Views
(@greg1234)
Trusted Member
Joined: 17 years ago
Posts: 33
Topic starter   [#23696]
Having a leveling issue, some floors are perfect while others are off a quarter inch.No reason for vanes to have moved.Wont recognize learn trip.



   
Quote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203

   
ReplyQuote
(@greg1234)
Trusted Member
Joined: 17 years ago
Posts: 33
Topic starter  
Tool says abort , car stops before reaching the needed 0 value at the bottom landing to initialize learn run.



   
ReplyQuote
(@hotsauce04)
Active Member
Joined: 17 years ago
Posts: 13

   
ReplyQuote
(@elev8d)
Active Member
Joined: 17 years ago
Posts: 5

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Originally Posted by hotsauce04
Try replacing your batt ram chips if it wont take learn run

When those Dallas RAM chips have been the issue, it has worked for me to just swap the 2. They aren’t bad, just like glitched. Of course I don’t know if this always works.



   
ReplyQuote
(@tnhapa84)
Trusted Member
Joined: 17 years ago
Posts: 60
 
Check and make sure your sensors are clean and dont have hoistway junk and dust. run the car down an inspection and make sure NTB goes lower case IN (menu or module ) M 2-1-3-1 i think then make sure ET1.



   
ReplyQuote
(@greg1234)
Trusted Member
Joined: 17 years ago
Posts: 33
Topic starter  
Hey guys I really appreciate the help, I will hopefully get it fixed and will reply back with what the issue was, thx a million!



   
ReplyQuote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203
 
Only one batram chip is really used, the other is backup. You are leaving the bad one in the backup socket on the board.



   
ReplyQuote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203

   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194
 
---------worn sheaves on machine and cables will cause cable slippage too much slippage throws the hoistway counts..off



   
ReplyQuote
(@greg1234)
Trusted Member
Joined: 17 years ago
Posts: 33
Topic starter  
Appreciate all the help guys, Len you where spot on, cables are slipping just enough to cause the count to be off.Thanks for your input!



   
ReplyQuote
Share:
Scroll to Top