Elevator Forum

Name that controlle...
 
Notifications
Clear all

Name that controller

14 Posts
10 Users
0 Reactions
8,931 Views
(@ashley)
Reputable Member
Joined: 17 years ago
Posts: 176
Topic starter   [#33347]
The data plate says Westinghouse, but Schindler says they have no record of it and it doesn't match their numbering system. Best I can tell it was a mod in the 80s but no record with the City having a permit pulled. Only original 1940s install. Original install is listed as a Keller not Westighouse
Anyone recognize it?
Attachments
cont2.jpg (865.58 KB, 95 downloads)
cont1.jpg (1.08 MB, 72 downloads)
cont3.jpg (702.89 KB, 65 downloads)
cont4.jpg (656.83 KB, 60 downloads)



   
Quote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203

   
ReplyQuote
(@stall-protection)
Eminent Member
Joined: 17 years ago
Posts: 27
 
Relays are definitely GAL and the reverse phase relay says GAL too. I've seen those relays on some old General Elevators though I'm not sure if they made their own controls.



   
ReplyQuote
(@eelevator)
Honorable Member
Joined: 17 years ago
Posts: 579
 
I think with the data plate saying Westinghouse it's a safe bet its a Westinghouse. I would look for castings in the machine too. Maybe not If it was a mod, but most of that old stuff they cast the company name somewhere on the machine.



   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798

   
ReplyQuote
 M2RE
(@m2re)
Estimable Member
Joined: 17 years ago
Posts: 82

   
ReplyQuote
(@ashley)
Reputable Member
Joined: 17 years ago
Posts: 176

   
ReplyQuote
 ABE
(@abe)
Reputable Member
Joined: 17 years ago
Posts: 338
 
I would agree on GAL as well. Often GAL and CJ Anderson would put the name of the company installing the controller on the controller data tag.



   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@ashley)
Reputable Member
Joined: 17 years ago
Posts: 176
Topic starter  
So, no luck on prints from GAL, does anyone have anything close? Problem I have is the car is always picking the UR relay, after it completes a run, it always runs to the top landing and just sits there. If you cycle power, you can push in the lower call manually and it will take but won't work off the button. After it completed that run, it reverses direction and returns to the top floor. Then won't take a call via the relay or button. This is an old freight with manual gates.



   
ReplyQuote
(@matol)
New Member
Joined: 17 years ago
Posts: 2

   
ReplyQuote
(@matol)
New Member
Joined: 17 years ago
Posts: 2

   
ReplyQuote
 M2RE
(@m2re)
Estimable Member
Joined: 17 years ago
Posts: 82

   
ReplyQuote
(@snkrhead)
Estimable Member
Joined: 17 years ago
Posts: 77

   
ReplyQuote
Share:
Scroll to Top