Elevator Forum

MCE FLOOR height ch...
 
Notifications
Clear all

MCE FLOOR height checksum error

7 Posts
3 Users
0 Reactions
7,934 Views
(@jimbonj)
Estimable Member
Joined: 17 years ago
Posts: 67
Topic starter   [#17958]
Manual is telling me it might be a faulty chip on the imc-ddp-c board in the ddp box . EEPROM bad , anybody ever unplug the chips and put them back and it re-set the fault ?



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Sounds like the U15 chip. It usually fails after changing parameters, I keep one on the van now as I have seen it 5 or 6 times now. Snap a picture of all your parameter screens, replace the chip, re-enter parameters & floor heights or do a learn run, then learn the terminals and you're back in business.



   
ReplyQuote
(@jimbonj)
Estimable Member
Joined: 17 years ago
Posts: 67

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@jimbonj)
Estimable Member
Joined: 17 years ago
Posts: 67
Topic starter  
I was not. Was a shutdown. Car level in lobby with doors closed. Motor limit timer LED Lit. The other led"s gave me the floor height checksum error



   
ReplyQuote
(@smitty)
Reputable Member
Joined: 17 years ago
Posts: 220
 
Common failure after about 5 years. Piece of cake now with cell phone cameras capture your adjustment screens.
Put a new one in, do a default all (per manual), then reenter your parameters from each screen,relearn your hoistway and relearn your limits.



   
ReplyQuote
(@jimbonj)
Estimable Member
Joined: 17 years ago
Posts: 67

   
ReplyQuote
Share:
Scroll to Top