Elevator Forum

Kone KMC 831 load w...
 
Notifications
Clear all

Kone KMC 831 load weigher

4 Posts
3 Users
0 Reactions
5,698 Views
(@ssharp)
Eminent Member
Joined: 17 years ago
Posts: 26
Topic starter   [#24235]
I have a question about the load weigher. When I go into menu 5-1 and it shows L 5 with the car empty does this mean it's 5%? From my understanding of these elevators that when you set up rhe load weigher you turn the pot until it reads 0 then load up the car and make sure it's set at 100 then when the car is empty again it should read 0 (+/-3). Am I right on this? Thanks in advance.



   
Quote
(@upanddown2321)
Trusted Member
Joined: 17 years ago
Posts: 96
 
Yes 5%. Ideally you want it set at -2/3 at the bottom. Run to the top and it should read fairly close. The Offset pot will set this. The gain shouldnt be touched unless you have the load inside the car. This is assuming you are using the analog VTC board.

Last edited by UpandDown2321; 06/29/18 04:01 PM.


   
ReplyQuote
(@ssharp)
Eminent Member
Joined: 17 years ago
Posts: 26

   
ReplyQuote
 BRG
(@brg)
Reputable Member
Joined: 17 years ago
Posts: 169

   
ReplyQuote
Share:
Scroll to Top