Elevator Forum

Notifications
Clear all

dover t4 trouble

8 Posts
5 Users
0 Reactions
11 K Views
(@vatorgator)
Honorable Member
Joined: 17 years ago
Posts: 432
Topic starter   [#17359]
have a very intermittent 56 fault, it will run a week, then fault 3 times within a couple minutes and shut down. it will run a couple days and do same thing, never seen it happen, replaced various relays, dsp board, it has a dsd312 drive, and it has no stored faults, so don't think it is an actual drive fault. also using fltn command, the last time it happened, it was floor level, with velocity at 0 it faulted on a 56 2 times within a minute or so, then it took off for a long run, 19 floors, it almost made it to the top, and logged a 56 at 451 fpm. this one is killing me, been going on for a month now. any ideas? also been thru m contractor and auxiliary contacts



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
Is C1 using a noise suppressor?
Is the C1 contactor spreacher CA6-85?
Is PS1 manufactured by Todd?
Check the wiring from your gate finder board.
I know you said the velocity was 0 but I think there was some trouble with the original encoders.



   
ReplyQuote
(@e-man)
Honorable Member
Joined: 17 years ago
Posts: 480
 
Find the drive page in the prints that has the 1M contactor. Replace each module and go over every contact on that page.



   
ReplyQuote
(@vatorgator)
Honorable Member
Joined: 17 years ago
Posts: 432
Topic starter  
thanks guys, i replaced the wdpf output module in mcf coil circuit and it has lasted 2 days with no errors, i will try your info out if it comes back in thanks again



   
ReplyQuote
(@vatorgator)
Honorable Member
Joined: 17 years ago
Posts: 432
Topic starter  
well lasted 4 days. then 56 error again. again car parked. no demand no velocity.
indertwetrust i replaced the DE input module, and the ES output module. will see.
sometimes you just got to love these damn elevators.



   
ReplyQuote
(@thyssenguy)
Eminent Member
Joined: 17 years ago
Posts: 24

   
ReplyQuote
(@vatorgator)
Honorable Member
Joined: 17 years ago
Posts: 432
Topic starter  
well replaced de input module, and es output module. 5 days with no errors. guess i should have kept it simple, and replaced de input module first will see looks good now. thanks indert.



   
ReplyQuote
Share:
Scroll to Top