Elevator Forum

Notifications
Clear all

Dover dmci

6 Posts
4 Users
0 Reactions
3,917 Views
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316
Topic starter   [#16087]
we're trying to change door op adjustments but they won't save to clc. Has anyone ever had this problem



   
Quote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798

   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
FastTool, Freedom, or some other tool? Maybe you've already done this, but do a reset on the door card, then try again.



   
ReplyQuote
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
If the reset didn't do anything, my money would be on the door card assuming you've got a good scan and DOL/DCL are present. When you make an adjustment, do you see it change value in the FastTool window? And if so, when you press SAV, what does the tool read back? Any door faults? And you've tried to make changes at the operator Dshell connector as well? And not to be smart, but you're looking at adjustments in the FRONT operator right? It's easy to double stroke the tool and end up at rear door adjustments.



   
ReplyQuote
 Len
(@len)
Estimable Member
Joined: 17 years ago
Posts: 194
 
I have seen instances where the clc has to be cleared of all faults in order to accept door operator parameter changes..also have had better success plugging into the car station communication port..



   
ReplyQuote
Share:
Scroll to Top