Elevator Forum

Dover DMC-1 not wor...
 
Notifications
Clear all

Dover DMC-1 not working

8 Posts
5 Users
0 Reactions
6,757 Views
(@hannibal)
Eminent Member
Joined: 17 years ago
Posts: 16
Topic starter   [#26823]
I have two elevators. One is running and the other one not. The problem when i power up the bad elevator the other one dont take hall calls. I have to turn of the cpu for the other one to work. The bad elevator close door and dont do anything. He run on inspection but not auto.



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Probably a bad CLC, you should be able to unplug the group comm on the bad car so you can power it up without taking down the group to troubleshoot. The bottom 2 plugs on CLC are comm, left, LCC10 is group, right, LCC9 is car. Without power and plugs off you should read 460-48 ohms from pin 2 to pin 4 land at least a Meg ohm from 3 to 1. On both LCC9 and LCC10



   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635

   
ReplyQuote
(@hannibal)
Eminent Member
Joined: 17 years ago
Posts: 16
Topic starter  
Hi, thanks for answer. I take out both plugs, and test both, LCC10 from 1-3 and 2-4 read 67 omh on both
LCC09 from 1-3 and 2-4 read 54 omh on both

I am reading the plugs not the pins on the board. Im right?



   
ReplyQuote
(@hannibal)
Eminent Member
Joined: 17 years ago
Posts: 16

   
ReplyQuote
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@take-the-stairs)
Estimable Member
Joined: 17 years ago
Posts: 120
 
have u replaced any boards, or software? make sure your software between the 2 cars are compatible. some of the newer software will not communicate with old.



   
ReplyQuote
Share:
Scroll to Top