Elevator Forum

Dover composite doo...
 
Notifications
Clear all

Dover composite door issues

5 Posts
4 Users
0 Reactions
4,338 Views
(@amullark)
Eminent Member
Joined: 17 years ago
Posts: 32
Topic starter   [#32370]
I have a Dover composite traction it is a bank of their elevators. Elevators 1 and 3 are no issues only on elevator 2 . only when homing to a floor the unit will not respond to the hall or car calls unless the CST relay then doors open and will take calls again both from hall and car until it homes again. when this happens the FT timmer comes on and stays on.



   
Quote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
I do not have a print in front of me, but what I remember is CS pulls in with the second slowdown and drops out when the door times out. If CS stays energized it will create a Failure timer. So whatever is not letting CS drop is causing the problem. It was commonly called a CS lockup in this area of the country. A lot of the time as I recall it could be caused by a hooked hoistway door. Good Luck.



   
ReplyQuote
(@johnny)
Honorable Member
Joined: 17 years ago
Posts: 473
 
You have to look and see what causes FT (failure timer) to pull in. When you pull in the CS relay to open the doors, something happened that didn't allow the doors to open, (no UC problem at lobby) and therefore FT timed in and that takes the car out of service. You were saying CST and that sounds like the circuit we used to get out of a CS lockup. CS lockup usually occurred when approaching a floor, not at the floor. But a FT can only happen at the floor. Sounds like there is also a zoning problem, since FT coming in should allow the next zone car to respond.



   
ReplyQuote
(@johnny)
Honorable Member
Joined: 17 years ago
Posts: 473

   
ReplyQuote
(@bobbybolognie)
Eminent Member
Joined: 17 years ago
Posts: 14

   
ReplyQuote
Share:
Scroll to Top