Elevator Forum

Dmc1 door close pro...
 
Notifications
Clear all

Dmc1 door close problem

16 Posts
5 Users
0 Reactions
11.6 K Views
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
Quote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
It’s intermittent and happens on all floors. WD Light on door board flickers and drops out. Door stays open.



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
An open motor armature will cause the watchdog to drop out. Check the motor & brushes. Other than that, verify your 12 & P150 voltages, if good replace door board.



   
ReplyQuote
(@philly)
Reputable Member
Joined: 17 years ago
Posts: 256

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
I can not find wd1 and wd2 on the print How would you properly check the door motor ?

Last edited by Jluff; 04/04/19 03:50 AM.


   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
WD1 is on when you have voltage at DA1, WD2 is in when you have voltage at DA2. To check the motor, unplug the leads, make sure neither read to ground, connect your meter across them reading resistance, rotate the motor a very small amount and stop until you get around several times. Every time the resistance reading settles it should be roughly the same resistance. If it’s ever very high, you have a problem. Make sure P150 doesn’t drop while running the motor. If it does, you may have a PY2 or PY4 board with no cap from P150 to G150 in the controller or a bad cap under the board. I kind of doubt it’s an encoder problem since the doors work in one direction and the encoder is just 2 optical switches.



   
ReplyQuote
(@philly)
Reputable Member
Joined: 17 years ago
Posts: 256

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
Happened again after 8 days working great. It was happening every 10 times or so the doors opened before replacing the door motor. Now I’m very confused



   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
Is The capacitor located on the PCB relay board in machine room? Does the whole board need to be replaced ? There is a 4-6 week lead time to order this board from vertical express.



   
ReplyQuote
(@ashley)
Reputable Member
Joined: 17 years ago
Posts: 176
 
Jluf You can get a board from World electronics shipped the same day, or for half the cost send yours in for repair.



   
ReplyQuote
Page 1 / 2
Share:
Scroll to Top