Elevator Forum

Me too indirtwetrust. Thanks

No can’t even see the job named folder but it’s there. So 2 copies of the original downloaded job file and just rename the same file twice to 07 &...

It doesn’t let you select all files. See attached photo. Drop down window has no other selections except the one shown. Attachments 73083858509__BB...

Wow! Ok! Says in the fast manual CST is off, so I thought it’s off, not on. Hope that’s all it is.Just don’t know why it says everything is ready and ...

Finally got back to this job. 5 - stop. This car is Master. Set CLC ADJ 52 =15, 53 =1, 56 = 15 and 57 = 1. No faults CLC shows CST SCA. Selector show ...

Did you run a power up confidence test?

Is it a traction or hydro?

Looks like you may have a CAN Comm problem. Measure CCH to shield and CCL to shield on the IOD. Should have about 2.5 VDC on each one. If bad pull the...

Ok, so got a FAST connected, cleared the faults, reset the selector, did a new HW learn. Doors open & close, no faults, looks ready to run, but wo...

Thanks for the advice EElevator. I did forget to mention that it is a wet unit.