Elevator Forum

Sometimes the instruction in the manual for hoist and door travel doesn't work very well. After entering all the CLC adjustments correctly, the best I...

Glenn, are you talking about the DMC door board 6300EH1 ?It has two microcontrollers, U6 (pulser) and U7 (Control).Control takes care of read all sens...

Hi, during the last months I did learn a lot. The door boards 6300PY1 and 6300PY3 in fact WILL WORK on the DMC, but it needs the eprom code 675-ET4. T...

We found it... the MCD relay (moving up - up to speed) was not latching, so VC2A and VC2B relays not latching either, car stops after moving 1 inch up...

Another CPU board installed, was programmed with the 5 files from the job, it behaves exactly the same. Hoist learning moves down to the bottom limit,...

Thank you EElevator for you answer.At the IMS Car IO Screen, I have FSH1 gray and FSH2 green. As no fire service is active, they both should be the sa...

... complementing... when you say "generic software", aren't you mean "generic profile - not yet customized", right?

Sorry, where can I get the generic software for the 6300PA6 ? What is the correct filename ? Thanks.

Now I got confused. What you transfer via ZMODEM and Hyperterminal is not a profile? So, there are two kinds of files, the "generic software" and "the...

And how do you reset the UIT to work in another installation? job?

I uploaded a working profile, then increased "close high speed" and save again with another name.Opened both files in PC using HEX EDITOR NEO, and fou...

Originally Posted by Indirtwetrust They’re in the installation of IMS. If you go to door Smart Fast then Transfer, click upload, then Default, then br...

Originally Posted by Indirtwetrust There aren’t different parameters but there are different acceptable ranges of some parameters. Those 2 boards aren...