Elevator Forum

Code 0075 61:U input missing 61:U Input not found Broken wire in traveling cable 1401 LCE can't see first floor front side control board (FCB) Sid...

Thanks john. Ultimately we convinced the building owners it would be more cost effective long term to do a mod. Hopefully the motion 4000 we suggested...

got what i needed. thanks everyone

I did receive prints from a nice someone on here but would still like to get a hold of a manual since I know nothing about these. Willing to trade. PM...

Give the tape a good cleaning and look for any damaged spots. Make sure the guide isn't worn. Check tape tension. Usually the back of the print has a ...

thanks for updating. yeah setting up parameters from a dead clc batt and figuring out the tool your first time is a pain. i would much prefer a dmc ov...

Check the following on your selector. - worn tape guides- fold down the selector board and look at the magnetic sensors. specifically the level up / l...

Make sure CFC relay drops out as it should. I once had some gunk on the back of the armature of the relay cause CFC to occasionally stick, causing res...

Hello hello, I'm not familiar with EC traction or Torin machines, but I have spent hours pulling my hair out adjusting a dozen imperial 525 gearless m...

Charlie, If you have a local trade/tech school I would see if they offer any classes specializing in motor controls, PLCs and micro-controllers (elect...

Hey, so I found a shorted coil on ES relay, which was likely causing some of my fuse blowing issues and maybe even the blown MOD-PLC board. So that ma...