Elevator Forum

Did you give a Barry a call? I PM'd you his number.

Did you try another learn run? Do you have the World Electronics service tool?I'd check the parameters first, to make sure that car call is enabled, a...

English is his 2nd or 3rd language, it appears. No problem, I'm just sayin'.

Scott, I think it was 3500 Wilshire, where as a newly 70% helper, I adjusted 9 Miprom 21s, with Allen Bradley drives, back in about 1986. Montgomery's...

That's not around 3550 Wilshire, is it?

Ok, Scott, I don't know as much about the problem as you do, haven't worked on a Miprom 21 with A/B drive for 25 years, BUT, since when has a lack of ...

Scary stuff! Once I was walking accross a parking garage, looking at an elevator about 200 feet away. With the doors wide open, it took off at full sp...

Put more test weights in it? If that's not enough, (because overspeed will make it fault out before hitting the rail switch), then maybe you could dis...

Thanks! Much Appreciated!

Too much posts? Uhm hum, ok. Obstruction, oh, ok, uh huh.

Some punctuation might help. Reads like one giant run-on sentence.

Oh, thanks...

What's "IMS" software?

I don't have anything on adjusting the drive right now, but if I find something, I'll pass it along.

I dont have my stuff with me, but if I remember correctly, 0104 is an overtemp fault on the drive. Its a two wire plug on the drive board, left side, ...