Elevator Forum

Hi. Do you have any Kone intruction for that ? I'm interested in what I'll see after connecting and what I can do there

Thank you

Yes, 501 controller, Kone TransitMaster. I found the parameter list and your are right, S03 is about the fan. There are 3 modes in S03, 0-1-2, do you ...

I need to know when the inverter starts own fans and how to set it.Maybe somebody knows it.

Look like the board was broken. I tried a new one and it’s working good.

The motor has number KM903375G04. Do you think the board will show an error code by led blinking? I think I would notice it, because I know about thos...

I haven’t seen the led State is flashing after learning. But I will check it again. I didn’t upgrade. The old board was AMD 15 606060g01-R and the new...

When the elevator had old AMD board, the doors slowed down in the both ends. But there was a problem about photocell, so we changed the board.S1SP0-OF...

Yes, leds “close end” and “ref switch” are on when the doors are fully closed. “Closing force” is in the midle. When I make “learning” and open the do...

Thank you for information. Can you send me the file? [email protected] 🙏