Elevator Forum

It could be interference. The encoder shield needs to be grounded.

Reset the parameters to factory settings and set them again using the KONE instruction for kdl16lAnd what about faults? Last edited by Vadim; 08/28...

I have got it, thank you

Set 3_36 0

First I would check the tachometer, even if there is no 0108. Then all 6 parameters(drive parameters), maybe it lost some of them. Sometimes it happen...

Does the elevator car is not stuck in the guide rails?You can’t update firmware and this drive will not have 6_75(real time monitor). Kone doesn’t sup...

What drive?

I had these issues in an elevator. I checked all and replaced some parts for testing before replacing the v3f16l. I noticed that if the drive runs for...

Did you look faults history ? E_1 (1=latest fault). Must be more faults in the history.

I guess you didn’t finish correctly 5_2_1. The shaft setup if finished correctly when you see in the end of moving - - - - If you not see it, you shou...

I had this situation with Kone Monospace, drive v3f16l. The reason was in the v3f16l. After I changed the drive with another elevator, the problem has...

What about errors?