Elevator Forum

There is a timer for the ebrake set time menu 5 sub 10. It does not sound like your problem if the washers do not spin you are picking the brake. In y...

The brakes should be set to .002 the noise will still be the but quiter ifratedpilot is right on the washer that is under the 15/16 head nut on both o...

Go to menu 5 submenu 7 change the 0 to a 1 hit accept let it do its thing when cpu say 5-7-1 cycle power then your done

Vic Yeah do you have a drive book?

4-1 says what mode it is in 0=normal 1=inspection 3=fire service 4= emergency power 10=out of service 11=independent service. There are more but these...

Oh top floor sorry yeah does menu 4-1 say its on normal? Also is it in a group?

You got it. Did you put that MX20 back in already?

77u is the top terminal switch 77n is the bottom terminal switch so u on at the top and n on at the bottom if both are on thats the problem 77d does n...

If the boar was bad you would get a 1401 1402 or what ever floor control board it was in the shaft usually the print will show you the pin count to tr...

Its easy there is a auto detect feature if you have a commish book it explains it it is easier to do with the ropes off just make sure rpol tpol are h...

36 is a secondary fault usually check the event log event 1 is the last thing that happened scroll through and you should find the fault that caused i...

V3f25 drives are great its the v3f16l that is not. I'm sure you fixed it by now but 103 resistor fault some times on the resistor stack i have seen th...

There will not be its referanced to ground through the lcehas board in the shaft sent to the controller through the network