Elevator Forum

Is this company still in Buisness?

That's the TKE job number

How about 300%, I've seen it.

It's not on that tag on the motor?

I'll try it.

You need the generic software from TKE and the special adapter to talk directly to the door operator. There is usually always generic software install...

I've seen some problems on that valve already. Had to rebuild. Not sure about the longevity of it though.

Floor validation for doors wrong on that DMC , recheck your chart.

Check or replace those Finder relays in the controller, they cause a lot of problems.

Try to trouble shoot CAN with the UIT tool.

Well if your CLC is an old version the new door board won't communicate with it, then you have to upgrade all the boards.

I bet it's the power supply, I've seen it many times.

What is the CLC board part number, is the board blue or green? Is it a BP2 ;, BP4?

I thought this was a MCE/ MCD fault? It's got nothing to do with LON. Replace all the finder relays on the boards, you have to replace the spring type...

What port do you have it plugged into? Use the 232 not the 485.Tac 20's are 16 bit, should work with regular IMS.