Elevator Forum

did you ever find something to work i know of a laptop version that works fairly well, i will see if i can get my hands on it.

compare 3 phase voltage, taken with voltmeter, to service tool reading of drive parameter #116. check calibration of of parameter 116, check setting o...

Im with the other guys on this one, if your going to modernize, and are going to choose one of the 4 main guys, Otis, Thyssen, Kone, and Schindler all...

I guess after reading my own post, it does seem to shed a bad light of laziness on myself and the trade in general. I guess my point was that at least...

those were the good old days, a bunch of guys sitting around shooting the Crap, and one of them receives a trouble call that has been plaguing him for...

I took the db25 pin end apart and checked it out, it has a circuit board that is connected to the db25 connector. only 4 of the 25 pins are being used...

it was a laptop version, they sell at world electronics for 4600 , the buyer got a great deal, the tool has been sold already. thanks for the reply.

los is a hard fault, reset it with the onboard diagnostic tool.

now thats refreshing, sounds like myself, 27 years ago. Im with you on the printless job, who in the hell takes the damn print anyway, i have been dea...

very strange, i was at the job to service today, this time i put the car on inspection at the top floor, anticipating having to press the door reset b...

you can buy them from vertex, not sure if that is the right spelling, i think they are owned by thyssen. the orange cable is a rs485 to rs232 converte...

you can buy them from vertex, not sure if that is the right spelling, i think they are owned by thyssen. the orange cable is a rs485 to rs232 converte...

mike you are so close, address 31 is correct for FLK floor lockout inputs. check your i/o sheet listing, io address 33-48 is the card reader lock out ...

pm me i have prints, you probably have it fixed already, as it has been a few days.