Elevator Forum

Originally Posted by elmcannic You’ve check the encoder couplings right? If motor end shaft mount, check for loose set screws or set screw type.If tha...

Originally Posted by Scarz3 Hi all.Been having problems with a couple of swift futura units. Usually they run fine for anything between 1 hour to 3 da...

Scrap that, it was the fan. Thanks.

It blows without the drive (including fans) connected to the drive pcb.

Sorted thank you, was the ICS module on TOCC.

Did you ever get to the cause of this?

Originally Posted By: NOTIME Do you have Wizard tool ? (laptop with Futura Software) Yes I do.

Here in the U.K., we're called "Lift Engineers" 🙂These units are few and far between over here.

Ok, used the frame playback, when the lift crashes, we get fault 94 and 24 in the same frame, and we also lose EMSD. Nothing else drops out.Does this ...

Contactors are all Schneider. No satellite dishes positioned near any of our equipment. Will have a go at using the playback tool on the wizard. Thank...

Thanks for your reply, sorry but what's MG?