Elevator Forum

I didn't mean that vatorgator. We have a bunch of open shop people around these hospitals and electricians who take over maint on some of our units. T...

Its obsolete time for a upgrade. Tell the customer to open up the check book.

Until you gain access to the settings and parameters you cant do or find anything. MAL=1 will grant you what you need. So until you do MAL=1 you are w...

What type of controls? Is this a link communication type button if not just buy something that fits the hole and wire in something new to work.

open order adjuster? Parts and Labor make it work....

How about other fixtures Cab Buttons, PI's key switches, Hall lanterns? Can you find a manufacture on those? What about the prints any info on those? ...

Under the system pull down on the door smart fast setting MAL=1 enables all adjustments(maint access level)

The 03 book has no info for that door card. What I did find for a 6300pa3. Which is a universal door board. Which you'll use the universal door smart ...

Jp1 1 to 2JP2 2 to 3Jp3 offJp4 off for front on for rearJp5 installed for 486 off for canJp6 offI pulled the wrong book that's for 6300paxx on a 04 I'...

You've checked the pico on saf3 and put a new module in it?

What fault are you getting? 109, 143, 102, 103, or 116? All these faults are associated with SAF3 opening. SAF3 is controlled by the car CPU. It's fun...

this is a 200 fpm car it might not use vanes for the ETS/L system. It prolly uses switches so I need to look for some information. Also I have only T4...

Originally Posted By: E-man Not trying to hijack this thread but I'm curious about say doing an Automatic Hoistway Scan (Learn trip/Floor Height Updat...

s Last edited by sbrmilitia; 06/08/14 11:22 PM.

another tip after you clean your p1 and p2 on the DSP and PM1. After power is restored and IMS is communicating. Type is FLTP. It will show all your p...