Elevator Forum

it is a drive or brake fault. I advice checking drive fault codes via tool.

maybe replacing SCIC may not be a solution. generally sim is broken. so if you have a bionic controller (bx, 3300 etc..) and also cadi you can check S...

Alex75, do you know terminal can be used instead of cadi bionic for 3300 model

can you show the cable photo by uploading

yes. it goes for learning trip although without sim and after trip if it can not read sim it behaves as you menioned.

sim Last edited by sampler; 07/31/22 08:07 PM.

check 2 hoisway magnets at the end of the shaft.

one day I acrossed that car was hitting limit switch while waiting on top floor. cause car pulley was slipping from belt. that was a 3300AP.

Sorry. I have to fix air gap issue. . if air gap is bigger than 0,5 mm it can be adjusted.And B can not be under 1.6 mm."1 Check if:a) There is excess...

If air gap A is smaller than 0.5mm u can adjust air gap. But when B distance becomes smaller than 1,6 mm you have to replace brake.this means that pad...

there is no heater. if oil temperature is the reason of this failure there's a reverse situation. Cause relevelling can not occur due to cold oil.

dear heisenberg, normally relevelling is working very well and many times tested. After hours, releveling may not occur due to cold oil or a valfe fai...

The error occurs in the morning and always car at the bottom floor, not actived final switch but 12 cmm down.hand tool errror: Warn: Bypass pr, Demand...

Dear Yus123, I have the same problem. Did you solve it. Can you help. Also Bucher 0-point has already been set and problems' going on.