Elevator Forum

No. Laptop program only

when doing 1-2-5-1 test hit enter, it will show you 2 I/O that are addressed same, if one is output and one is input that's ok, then hit enter again a...

Make sure your card reader board is plugged into car link too.

If your car button I/O board is addressed 8, then make your crc board address 16or 24. Set 326 to address 16-1 or 24-1. You need to wire the inputs. I...

line terminators are very important yes and wherever you need one will be shown on your wiring diagram

Check addresses at I/O 1-12 (car calls) thencheck addresses at I/O 161-172 (card reader inputs)They will need to be different from each other. You wil...

To start with do a duplicate i/o test # 1-2-5-1.You may have another input addressed the same as 326 which may be causing your problem. I will chec a ...

Look like Innovation industries

Thx, it ended up being a loose wire on A3 studblock

If you can enter car calls ,on ph 2, ind serv, etc., then you are probably right about sec. int. issue. Where do the wires from card reader companies ...