Elevator Forum

We have reset it over and over and over and cleared the ram as well with no success. I don't know if there's a special reset for the MTH but nothing s...

We have 4 laptops from Tom. Recommend the latest version. Does many many things. Very helpful

I have a blue tool and a laptop that simulates a blue tool. I have seen prints that have the parameters and the setting in them but this job has no pr...

I've tried that many times but still have no shaft communication

All of these and even for floors we do not have. It's a 5 stop and I get those codes for a 40 stop. We have changed lcecpu boards nodes etc and perfor...

I managed to fight my way through it and get it done but there is no usb thumb drive on the job that usually has the manuals on it as well so I will t...

What is the speed? Above or below 200 fpm, spring or hydraulic buffers?

K got some files from a friend and left the boot jumper on 2 and 3 on a replacement cpua board and it worked. This is a replacement for the replacemen...

If I leave the boot jumper on 2 and 3 it will not flash the z code as stated in the manual. The generic file does not appear to be on the stick just t...