Elevator Forum

Problem solved, thanks.

Changed position magnets and did some adjustments, all ok 🙂!

Thank you, found the fault. Jab - top limit switch triggered, elevator returning to bottom floor - Blocked 🙂.

the error is read from the display board, we solved this issue at the time. but if anyone have some sort of documentation / error code list etc i woul...

Heard of this a lot of times, but usually it is the seals that causes leakage. Could it be that the manual lowering solenoid have been adjusted wrong ...

The problem is that i need to change the drive, and i dont have any documentation / parameter list.

Hello! Gen2 noises usually comes from the counterweight. loose plate on top of the concrete weights. The belts should never be lubricated. but you can...