Elevator Forum

Seems like doing a relearn on the door operator has this issue solved. Why all of a sudden the door was faulting out fully open is just one of those s...

Thanks guys for your input. I forgot to mention that I did do a relearn on the last visit so fingers crossed that the issue will go away. if not then ...

PM sent

I read you did a ADON learn and a shaft setup but did you do a decel learn as well? The 106 fault has something to do with the slow down resistors rea...

Off the top of my head I think 2301 fault is that CPU is not seeing a hall board. Try pulling the XM16 plug on the right side of the CPU and power off...

They pulled the coil wire off the up fast coil then placed a top floor call. Y delta pulled in pump would run then PT timer would time out doors would...

Gentlemen, first off thank you for your quick response to my issue. We replaced all four timers to be sure that they were functioning properly and sti...

I don’t have a BOR relay on this controller. I went ahead and ordered new timers as these look original and see what happens from there.

Relay logic. Also would like to know what the to set the UST and TS timers too?

213 fault is that CPU not seeing floor node. If you have replaced any floor boards in the hoistway make sure the pin jumpers are in the right position...

My gut is telling me you have an issue with the light ray board. I’ve had them malfunction after lightning storms. Hang in there with being new to tha...

Check brake gap adjustments and set brake switches accordingly. I put a dab of glue on the set screws of the brake switches to be sure they don’t back...

I would go over the e brake itself. Check for proper gaps. Possible mechanical binding of the brake. Center washer should have play in it. Brake micro...