Elevator Forum

What exactly are you trying to configure?

Thanks for letting us know, glad you got it!

Ok thanks for the info, do you have to send your old one back?

Nice! Do you happen to know the price?

Gotcha, To answer your question I believe smartrise gives you the option bc you have to be able to turn it off to dial in the floor levels from the co...

I am not super familiar with smartrise but the re-level option is on various controllers to have the option to re-level with doors open, closed, or no...

Make sure you reset the controller after changing the board so it scans for the new node. Sometimes you may need to drain the CAP on cpu. I assume you...

Yes the state light flashing will get you a sequence on flashes that correspond with a fault If you go back take a picture or tell us what leds are on...

Double check that your state light is not blinking, which motor are you using? I believe when KONE upgrades board only certain motor(s) work for that ...

Try a new door learn and save it

Does your state light flash at all after the learn?Should be 1 sec on 1 sec off - count the flashes if so.Were you upgrading like for like or was it a...

I would suspect the encoder on the motor.What are your dip switches set to?

Also is your closing force pot maxed out to the right?

Are you seeing close end and ref switch leds high when door is fully closed?

I agree with Montana, let a professional handle this. Not worth the risk of getting yourself or others hurt. You have checked the basics and taken it ...