Elevator Forum

that's to go up. to go down, hire a homeless person and give him a tutorial on manual lowering, have him sit in the equipment room for 8 hours, then h...

take one of the bikes, gerryrig it to a pump on a roped hydro, go to the YMCA, get some people out of their spin class and get pedaling.

www.techstreet.com/A17.1

there is no physical do limit, it uses the encoder to set it. you have to make sure the switch sw3 is correct for the type of door you have. you can m...

door open limit?

I suggest you buy the code book A17.1 2010, for the latest on US fire service, the details are many and the question is a little ambiguous.

they were a stock item on most HS controlled hydro's and used rarely on some Miprom units.

I have had odd faults with the WG Door Operator that were caused by the nut on the bottom of the worm gear operator being loose. Reach under the worm ...

green outputs _uj or _dj for hall calls, _cj for car calls. these go high when the associated input is activated. however if you have a bi logic unit ...

The VP 10 faults are feedback faults from the motor encoder and the CP 18 faults are arm. current unbalanced faults. I would check to see if a corner ...

I have seen similar problems many times, usually an output or input board is bad and when that particular board goes high it will light up everything ...

when you say reset, does the cpu blink reset? do you have the new style cpu? usually they are not intermittent. The older ones are plug and play. The ...

the miprom is confused it doesn't know what to do. the doors aren't actually opening are they? you may have a bad input board, or the computer is seei...

the magnet could be upside down.

the 42 is generated when the cpu sees the 90% speed sw. on the ets bd. out of tolerance. this happens on acceleration. there are a number of small spe...