Elevator Forum

Your problem will be the zone restrictor. I just put in a MOVFR and removed a TK HD-LM operator. It had an ESI controller. Didn’t change the header. B...

Oh. I thought the bcx (brake control board ) was part of the KDL 16s drive. Where is this module located. In the silver brake module unit on side of c...

The brake control board is internal in the drive ? Or it’s part of the brake control module on side of controller. Silver box ?

I should probably replace the brake control module also

I will take out the drive tomorrow. Hopefully it can be repaired. I can imagine the price is very high to get new from Kone

Thanks dirt. So The entire drive needs to be replaced ? Last edited by Jluff; 04/06/22 11:29 PM.

After the 0126. A 0106 will pop up. Inverter not ok. Braking resistor damaged Check tachometer and thermal switch connections My brake relays look goo...

I did not get to the top of shaft yet. The car is down low. Inspection faults out also so I can’t move the car. Safety led stays lit during fault .. i...

3075 sub code. I do not have this sub code on 0126.

It’s not the ups. Changed 6-12 to 0. Won’t move on inspection or auto. Everything says ready then as soon as car gets drive up or down it faults F-1. ...

Update on this. As soon as I put car on inspection I get a 0021 Saftey chain fault. But the Eaton 5p 850 battery unit is beeping low battery. This is ...

1030 was the first fault once. Last time it was 1040 first I believe the magnets on back of tape on terminal landings need to be smooth with no gaps....

How does the suppressor wire in to a plug in relay ?